last outing, it's become apparent that I should no longer , just go by eye when it comes to back country cooking. anyway, I want to make two indentations to mark the one and two fluid cup levels in my snow peak cook/mug. In my online searches I have stumbled onto a few mentions about this process, using a small section of #12-10 copper wire(the die?) Along with a bench vise. to create the mark. but other than that- no practicable mention on how it's done. does anyone know of a Instructable or some other diy site that can walk me thru the process? I have never worked titanium and would hate to ruin an expensive piece of gear, the first time out the gate.


Edited by the-gr8t-waldo (07/18/15 05:21 PM)