You can make a nice "tea" light lamp by using a 1/2 size (short) soda pop can, use the pull top as a hanger.
Empty/drink the soda.
Cut a 2x2 or 2.5x2.5in. window in the middle of the side (?).
Drink a 20oz. Pepsi then cut out the entire middle section of
plastic, this will be your window. Split the ring of plastic so it will slip around the short soda can.
Punch a few small draft holes below the window level.
Put a bit of sand in the bottom of the can then put your tea light in the sand, light it, snap on the plastic window.
It has a built in reflector and is wind proof.