Backcountry Forum
Backpacking & Hiking Gear

Backcountry Forum
Our long-time Sponsor - the leading source for ultralite/lightweight outdoor gear
 
 
 

Amazon.com
Backpacking Forums
---- Our Gear Store ----
The Lightweight Gear Store
 
 WINTER CAMPING 

Shelters
Bivy Bags
Sleeping Bags
Sleeping Pads
Snow Sports
Winter Kitchen

 SNOWSPORTS 

Snowshoes
Avalanche Gear
Skins
Hats, Gloves, & Gaiters
Accessories

 ULTRA-LIGHT 

Ultralight Backpacks
Ultralight Bivy Sacks
Ultralight Shelters
Ultralight Tarps
Ultralight Tents
Ultralight Raingear
Ultralight Stoves & Cookware
Ultralight Down Sleeping Bags
Ultralight Synthetic Sleep Bags
Ultralight Apparel


the Titanium Page
WM Extremelite Sleeping Bags

 CAMPING & HIKING 

Backpacks
Tents
Sleeping Bags
Hydration
Kitchen
Accessories

 CLIMBING 

Ropes & Cordage
Protection & Hardware
Carabiners & Quickdraws
Climbing Packs & Bags
Big Wall
Rescue & Industrial

 MEN'S APPAREL 

Jackets
Shirts
Baselayer
Headwear
Gloves
Accessories

 WOMEN'S APPAREL 

Jackets
Shirts
Baselayer
Headwear
Gloves
Accessories

 FOOTWEAR 

Men's Footwear
Women's Footwear

 CLEARANCE 

Backpacks
Mens Apparel
Womens Apparel
Climbing
Footwear
Accessories

 BRANDS 

Black Diamond
Granite Gear
La Sportiva
Osprey
Smartwool

 WAYS TO SHOP 

Sale
Clearance
Top Brands
All Brands

 Backpacking Equipment 

Shelters
BackPacks
Sleeping Bags
Water Treatment
Kitchen
Hydration
Climbing


 Backcountry Gear Clearance

Topic Options
Rate This Topic
#155882 - 10/16/11 02:44 AM Help with simple tent designs for DIY project
Wolfman Offline
member

Registered: 08/28/11
Posts: 20

I am looking to make my own tent this winter, and was looking for design options.

Requirements:

1 Sleeps 3 people (Me and my two kids) Some were around 70" x 90"
2 Supported with two trekking poles
3 Single layer top
4 Tub bottom and mesh sides
More??

I know about the Bilgy tent and that might work as a start, I am thinking I will have to make a mockup or one out of blue tarps to get everything worked out before I start with the actual materials.

So I was hoping that any and all of you could link or show me different designs of tents that you think might work. At this point I am just trying to gather designs and ideas before I actually start the work.

Thanks for any help,
Wolfman

Top
#155884 - 10/16/11 09:02 AM Re: Help with simple tent designs for DIY project [Re: Wolfman]
Gershon Offline
member

Registered: 07/08/11
Posts: 1110
Loc: Colorado
This is a design given to me by a well known hiker of the AT. It would be simple enough to add a bathtub and netting for those that can sew. It can be made with this tarp from Campmor although he uses a lighter material.



Edited by Gershon (10/16/11 09:10 AM)
_________________________
http://48statehike.blogspot.com/

Top
#155889 - 10/16/11 12:21 PM Re: Help with simple tent designs for DIY project [Re: Gershon]
Wolfman Offline
member

Registered: 08/28/11
Posts: 20
Thanks Gershon,

I think I will probably end up with some kind of A frame deign, it just seems a lot easier to make then anything else I have seen. But I am still open to any and all ideas, at this point I am just trying to get some ideas.

Wolfman

Top
#155890 - 10/16/11 12:25 PM Re: Help with simple tent designs for DIY project [Re: Wolfman]
frenchie Offline
member

Registered: 10/05/05
Posts: 461
Loc: Lyon, France
A large teepee or pyramid design is quite easy to make.
Works with a long pole or two normal ones connected.

Top
#155901 - 10/16/11 04:29 PM Re: Help with simple tent designs for DIY project [Re: frenchie]
Wolfman Offline
member

Registered: 08/28/11
Posts: 20

Thanks frenchie,

I found the Golite Shangri-La 5 it's bigger then what I want and way over my budget but I like the design. Maybe two opening as opposed to just one.

Do you know of any other designs or companies that make the same style of tents?

Wolfman

Top
#155903 - 10/16/11 05:13 PM Re: Help with simple tent designs for DIY project [Re: Wolfman]
RHodo Offline
member

Registered: 01/22/09
Posts: 60
Loc: Texas Hill Country
At http://www.equipped.org/tarp-shelters.htm you'll find numerous ideas for folding square and rectangular tarps into some form of shelter. Look it over for ideas to see if adding a floor and webbing to any might be a start.

You mentioned the bilgy so here's an idea for a variation. Broaden the front and support it with 2 poles. Sort of like this...
http://www.equipped.org/graphics/tarps/image132.jpg

but keeping the overall bilgy design. You'd wind up with a bilgy that has a triangle roof. Good luck.

Top
#155911 - 10/16/11 08:08 PM Re: Help with simple tent designs for DIY project [Re: Wolfman]
Franco Offline
member

Registered: 04/05/04
Posts: 1010
Loc: Australia
If you like the mid design, take a look at the BD Megamid.
You could add the floor/mesh yourself.

Now I see it isn't for sale any longer but you may find one SH
still on the Moontrail site if you want to have a look at it.
You could also look at the SD Origami or the MH Kiva, possibly all discontinued also.
Franco


Edited by Franco (10/16/11 08:19 PM)

Top
#155941 - 10/17/11 11:43 AM Re: Help with simple tent designs for DIY project [Re: Franco]
finallyME Offline
member

Registered: 09/24/07
Posts: 2710
Loc: Utah
Tarptent has instructions on their site for you to make your own. You can make it a little bigger to accommodate 3. I recently made a copy with a few mods that fit 3 adults close, and would probably fit one adult with two kids pretty nicely.

_________________________
I've taken a vow of poverty. To annoy me, send money.

Top
#155988 - 10/17/11 08:08 PM Re: Help with simple tent designs for DIY project [Re: Wolfman]
PDA Offline
member

Registered: 10/05/10
Posts: 75
Sewing the mesh sides to the canopy looked to me to be the most difficult part of the Bilgy tent. SO I was happy to see this
http://www.rayjardine.com/ray-way/Tarp-Kit/Net-Tent/index.htm
Which looked to be much easier to make, and also to "design" by modelling (prototyping) in , say, tulle plus blue tarp material for the bathtub floor. Get this to a comfortable size for the three of you, then source a tarp to cover. I'm sure this inner/outer concept would be much easier to make (no triple seams on a taper for example as in Bilgy)

Top
#155990 - 10/17/11 08:57 PM Re: Help with simple tent designs for DIY project [Re: PDA]
james__12345 Offline
member

Registered: 10/06/10
Posts: 189
Loc: Tennessee
I recently made the bilgy tent. The "taper" isn't hard at all to cut. You just take a rectangle of the material, measure a particular distance from the right on one end, and from the left on the other end. You then cut a straight line between the two marks. As far as the triple seam, you sew the mesh to the roof, then the overhang to the two. It's not the easiest thing in the world, but it's not all that bad.

Top
#155992 - 10/17/11 09:51 PM Re: Help with simple tent designs for DIY project [Re: james__12345]
PDA Offline
member

Registered: 10/05/10
Posts: 75
James - I followed your thread on the Bilgy tent and congratulate you on a beautifully executed job. However, I feel that for me, the level of accuracy in cutting and sewing would be beyond my competence, and I might well end up with something which might (emphasise "might") work, but would look like a bag of laundry. I am also somewhat concerned that the tapers would be bias cut an therefore weaker than the straight cut edge of the top piece. A second consideration was the OP's requirement for room for three. Prototyping the inner will be easier than re-sizing the BILGY, and then a suitably large straight tarp used for the outer - he doesn't have to put on beaks or doors like Jardine, although they would be desirable.
The disadvantage would be the additional weight of the top pieces of the inner tent and also of not tapering the tarp roof.

Top
#156009 - 10/18/11 02:14 PM Re: Help with simple tent designs for DIY project [Re: PDA]
frenchie Offline
member

Registered: 10/05/05
Posts: 461
Loc: Lyon, France
You should start modelling from the chosen design with paper, or on your computer, with google sketchup, which is a free and very useful software.

Top
#156057 - 10/19/11 10:22 AM Re: Help with simple tent designs for DIY project [Re: Wolfman]
Wolfman Offline
member

Registered: 08/28/11
Posts: 20
Thanks for all the help folks, not sure if this is getting any easier though!

Franco; I looked at those designs, I like the height of the center pole designs and the space but I am not sure how it would work with three people. I think the pole needs to be offset some. Also, although the pentagram of hex seem to have bigger floor areas I think I want to stick to a rectangle for ease of location selection and a simpler design.

finallyME; nice tent, I bet it dose great in bad weather! How is the condensation with three people? One of the things I really want in this tent is the ability to set up in it, at 6' 6" I need at least 48" just to clear my head, it would be nice to have more then that.

PDA; Interesting option, but I would rather have it all as one tent. I mainly camp in the PNW and bugs are always an issue.

James; You did a great job on your tent! Did you ever get it so it was not so slippery?

So I downloaded Sketch-up and am trying to learn that, but I think I am down to two basic designs. Something like the Shangri-La 5 Tent



OR something like the Rainshadow 2



Neither of these tents will be that easy to make but I think I can do it if I take my time. Maybe, well see. smile

Anything else, or other ideas on basic shapes and designs? I still have lots of time to get this all figured out!

Wolfman


Edited by Wolfman (10/19/11 10:33 AM)

Top
#156061 - 10/19/11 11:33 AM Re: Help with simple tent designs for DIY project [Re: Wolfman]
james__12345 Offline
member

Registered: 10/06/10
Posts: 189
Loc: Tennessee
I didn't get to put that other coat of silicone on it before my cousin came up from Florida for out trip. We found a good level spot, and it was perfectly fine on that trip. I have been very busy ever since with work (our cabinet shop is booked up till into January now), so I haven't got around to doing it since. As long as you have a reasonably flat spot, its not really a problem though. Thanks for the compliments on the tent to all that have commented on it.

When RHodo suggested using the two poles in the front, I thought of the rainshadow 2, but couldn't remember the name of it. Personally I dont know that I would be comfortable trying to make something with a regular curved tent pole like that though. It seems it would take alot more precision to properly take the tension of the pole. Even if you need to stick with only two trekking poles for the front, I would consider doing short vertical tent poles in the back similar to the designs that only use trekking poles. It seems like all the DIY designs stick with straight poles, and I figured the reason for that is them being more difficult to work with. I've never dealt with using a bent pole like that though, so it may not be as hard to work with as I'm thinking. Someone else here may have some experience with it that could chime in.

Top

Shout Box

Highest Quality Lightweight Down Sleeping Bags
 
Western Mountaineering Sleeping Bags
 
Lite Gear Talk - Featured Topics
Backcountry Discussion - Featured Topics
Make Your Own Gear - Featured Topics
Featured Photos
Spiderco Chaparral Pocketknife
David & Goliath
Also Testing
Trip Report with Photos
Seven Devils, Idaho
Oat Hill Mine Trail 2012
Dark Canyon - Utah
Who's Online
0 registered (), 170 Guests and 0 Spiders online.
Key: Admin, Global Mod, Mod
Newest Members
Noodles, McCrary, DanyBacky, Rashy Willia, WanderBison
13240 Registered Users
Forum Links
Disclaimer
Policies
Site Links
Backpacking.net
Lightweight Gear Store
Backpacking Book Store
Lightweight Zone
Hiking Essentials

Our long-time Sponsor, BackcountryGear.com - The leading source for ultralite/lightweight outdoor gear:

Backcountry Forum
 

Affiliate Disclaimer: This forum is an affiliate of BackcountryGear.com, Amazon.com, R.E.I. and others. The product links herein are linked to their sites. If you follow these links to make a purchase, we may get a small commission. This is our only source of support for these forums. Thanks.!
 
 

Since 1996 - the Original Backcountry Forum
Copyright © The Lightweight Backpacker & BackcountryForum