Backcountry Forum
Backpacking & Hiking Gear

Backcountry Forum
Our long-time Sponsor - the leading source for ultralite/lightweight outdoor gear
Backpacking Forums
backcountry gear

---- Our Gear Store ----
The Lightweight Gear Store

Bivy Bags
Sleeping Bags
Sleeping Pads
Snow Sports
Winter Kitchen


Avalanche Gear
Hats, Gloves, & Gaiters


Ultralight Backpacks
Ultralight Bivy Sacks
Ultralight Shelters
Ultralight Tarps
Ultralight Tents
Ultralight Raingear
Ultralight Stoves & Cookware
Ultralight Down Sleeping Bags
Ultralight Synthetic Sleep Bags
Ultralight Apparel

the Titanium Page
WM Extremelite Sleeping Bags


Sleeping Bags


Ropes & Cordage
Protection & Hardware
Carabiners & Quickdraws
Climbing Packs & Bags
Big Wall
Rescue & Industrial






Men's Footwear
Women's Footwear


Mens Apparel
Womens Apparel


Black Diamond
Granite Gear
La Sportiva


Top Brands
All Brands

 Backpacking Equipment 

Sleeping Bags
Water Treatment

 Backcountry Gear Clearance

Topic Options
Rate This Topic
#121451 - 09/24/09 06:14 PM Water bag with a spout?
GqGeek81 Offline

Registered: 06/17/03
Posts: 601
I've been looking at the Platypus cleanstream but I have a few issues with it.

I don't need the 'clean' bag that the filtered water ends up in as I will likely be using gatorade bottles.

I've noticed you can buy just the filter which has me thinking about just putting on a 'hiker's friend' style set up per Jardine.

I haven't been able to find a bag with a spout however aside from ULA's Amigo and the Seychelle setup which both come with a filter. The platypus tank bags and their Big Zip hydration bladder would work but I'm not saving much if any money over just buying the whole Cleanstream and tossing the bag I don't need.

So... does anyone either know of a suitable lightweight bag with a spout or know of an easy way to install a spout on something like the Antigravity gear bag?

I'm NOT wanting to run a siphon tube as I find that a bit fiddly, nor do I like the method Jardine suggests to do it using a ruber band and synthetic sinew.

I may be able to make a suitable bulkhead fitting with some threaded nylon tubing from the local bigbox hardware store along with some nylon nuts, washers and orings but I was curious if someone has a better idea.

#121460 - 09/24/09 09:33 PM Re: Water bag with a spout? [Re: GqGeek81]
DJ2 Offline

Registered: 01/06/02
Posts: 1348
Loc: Seattle, WA
The box wines and the boxes of coffee from Starbucks come with spouts.

The only way to fill them, however, is by popping off the spout housing.

#121463 - 09/24/09 09:58 PM Re: Water bag with a spout? [Re: DJ2]
Spock Offline

Registered: 01/10/06
Posts: 679
Loc: Central Texas
I've used box wine bladders for years. They work fine once you get the hang of jerking the valve off.

#121497 - 09/25/09 04:48 PM Re: Water bag with a spout? [Re: GqGeek81]
GqGeek81 Offline

Registered: 06/17/03
Posts: 601
Here's what I worked out today.

I used the Nalgene bottle method to create a bulkhead seal through a wally world nylon dry bag.

The projects you'll find online doing this also mount a filter inside the bag. I did not go that route as I intend to use a CleanStream filter hanging below the bag.

In the middle of the Nalgene bottle top I drilled a 3/4" hole with a Fostner bit because its what I had handy.

I then put a #13 oring from Lowes in the threaded side of a 3/8" barb by 1/2"MIP nylon fitting.

I found a push to connect fitting in Lowes that had a female 1/2" threaded plastic section and a brass end on the other side. Its kind of hard to describe but the female end is obviously meant to screw on while the rest remains stationary. The female part has 3 'wings' so its sort of like a wingnut. You'd know it if you saw it.

I pushed/screwed in the threads of the nylon barbed fitting onto the lid and on the inside of the lid I screwed on the wingnut to tighten things up and keep it from being able to pull out the lid. The wings work perfectly to act as a washer and make it easy to screw on.

I cut off the top section of the water bottle and left a bit of the shoulder on it. I smoothed the edges here. I've got some fine mesh I intend to stretch over the opening and secure with a rubber band to act as my pre-filter.

I then cut a hole in the center of the bottom of the bag that's probably 1-1/4" I just sort of eye balled it but it obviously needs to be smaller than the opening of the Nalgene bottle.

From inside the bag I pushed the chunk of bottle against the bottom of the bag trying to keep it centered with the hole in the bag in the middle of my bottle piece. From the outside, screwn down the lid with the fabric stuck between the two. You end up with a sack with what looks like a nalgene lid stuck to the bottom and a nylon barb fitting poking out of that.

I'm hoping to swing by REI this weekend and pick up a CleanStream filter and do some testing.

Just trying it out in the kitchen with a good gallon or so of water it was very promising. The Nalgene lid seals 100%. The fittings through the lid seal about 99%. It has a very very slow drip that wouldn't hurt anything.

I had a green thread protector from Lowes handy that fits perfectly over the barb. Its meant to push on the end of a bolt that sticks out on say a swing set and keep the metal from poking or cutting someone. It fits over the barb tight enough to act as kind of an inverted cork. This will likely be handy to stop up the barb while collecting water when I don't want hoses hanging all over the place.

I'll probably get a on/off valve and shower head fitting from REI that's meant for a camp shower bag. This will then work for water collection, especially when putting out the camp fire, as well as filtration and a shower.

I'll post pictures and weight once I've got it all put together.
It sounds like this will save me a good $30-40 over buying the whole Cleanstream and arguably do more.

#122329 - 10/13/09 03:24 PM Re: Water bag with a spout? [Re: GqGeek81]
Bear Cavalry Offline

Registered: 10/11/09
Posts: 27
Loc: Keweenaw Peninsula, MI
I was also thinking of box wine bags. Stop by you local frat, they should be able to hook you up.

#125501 - 12/18/09 02:20 PM Re: Water bag with a spout? [Re: Bear Cavalry]
CactusPete Offline

Registered: 12/18/09
Posts: 1
Loc: Pennsylvania
Can someone explain how to "pop off" the spout on wine bags? And are some easier that others?



Shout Box

Highest Quality Lightweight Down Sleeping Bags
Western Mountaineering Sleeping Bags
Lite Gear Talk - Featured Topics
Goose Down Question
by Bill Kennedy
Today at 04:56 AM
Back pack frame length
by Petro1234
Yesterday at 08:42 PM
Pullover vs Zip Rain Jacket
by 4evrplan
09/13/18 05:12 PM
Backcountry Discussion - Featured Topics
Whsiperlites: Catch the flame or let it go out?
Today at 03:03 AM
Donnell Fire in the Sierra
by balzaccom
09/10/18 08:51 PM
Leaving a Mark
by balzaccom
07/10/18 09:32 PM
Make Your Own Gear - Featured Topics
Pack Attachment Angle
by 4evrplan
09/21/18 09:04 PM
Featured Photos
Breakneck Ridge, New York
May 2012 Eclipse, Lassen Park
New Years Eve 2011
Trip Report with Photos
Seven Devils, Idaho
Oat Hill Mine Trail 2012
Dark Canyon - Utah
Who's Online
2 registered (), 43 Guests and 0 Spiders online.
Key: Admin, Global Mod, Mod
Newest Members
Phil Harvey, RyannBoehm, disguisedrob, grantwiley, Korak
12644 Registered Users
Forum Links
Site Links
Lightweight Gear Store
Backpacking Book Store
Lightweight Zone
Hiking Essentials

Our long-time Sponsor, - The leading source for ultralite/lightweight outdoor gear:

Backcountry Forum

Since 1996 - the Original Backcountry Forum
Copyright © The Lightweight Backpacker & BackcountryForum